This shows you the differences between two versions of the page.
— |
cso:instruments:zspec:shutdown [2014-10-07 02:45] (current) sradford created |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== Shutdown ===== | ||
+ | ==== Hand Off to Another Observer ==== | ||
+ | |||
+ | If you are remote observing and someone else is taking over: | ||
+ | |||
+ | - Contact the next observers to verify they are ready to observe. | ||
+ | - Save the observing log. | ||
+ | - Verify the new observers have control of the telescope and the transition went smoothly. | ||
+ | - Disconnect from the vnc desktops. | ||
+ | |||
+ | ==== After observing ==== | ||
+ | |||
+ | - Close the shutter, stow the telescope, etc., following these [[cso:observing:operating#after_observing|instructions]]. | ||
+ | * When remote observing, close the shutter before sunrise. | ||
+ | - Stop the secondary wobbler. | ||
+ | * In the UIP xterm, \\ ''__uip__> **secondary /stop**'' | ||
+ | - Stop the slicer: ''ctrl-C'', then exit IDL. | ||
+ | - Stop data acquisition. In the //Z-spec// desktop, in the wakea xterm, \\ ''wakea$ ** zspec_shutdown**'' | ||
+ | - Start a new fridge cycle. | ||
+ | - Stow the telescope, \\ ''__UIP__> **stow**'' | ||
+ | * If necessary, idle the telescope \\ ''__UIP__> **idle**'' | ||
+ | - Disconnect from the vnc desktops. | ||
+ | - At the telescope, follow the [[cso:observing:operating#after_observing|instructions]] and leave the computers ready and the control room tidy for the next observers. |